PA hotmelt low pressure molding
Vertical Injection Single Working Station Dual Guns with Dual Separate Tanks


Vertical Injection Single Working Station Dual Guns with Dual Separate Tanks

  • Intuitive touch screen operation, which is on the rotary operator.

  • Air over oil cylinder gives large clamping force for larger part.

  • Two independent injection guns.

  • Dual 7 liter melting tanks. Run different molding materials at the same time.

  • LPMS specially designed melt-on-demand tank can melt down the resin swiftly and evenly.

  • The gear pump is made of hard-wearing material,which is stable,injection volume accuracy ±0.1g,maximum shot size is 5g/s.

  • Injection pressure range 1~50kg, which is controlled by pneumatic safety valve. 

  • Linear scale it’s precise for mold clamping, does not need to adjust the reed switch position.

  • Six thermal control zones for precise melt control.

  • Light curtain and dual palm buttons for operator safety.


      LPMS® machines are engineered for low pressure molding, using specialty resins to encapsulate delicate parts, like automotive electronics, PCBA, coil, fiber-optic, LED lighting, cable, etc.

      The benefit of vertical injection is that when smaller parts allow the cavity to be split into two or four cavities. This allows shorter runners and higher output per cycle. It’s suitable for multiple cavity mold for cable, wire harness, LED, etc.


Machine Size / Weight

49.01 in x 37.20 in x 77.95 in / 1454 lbs


49.01 in x 66.93 in

Working Station Height

1120 mm   |   44.09 in

Packing Size / Weight

52.36 in x 37.80 in x 83.86 in / 1543 lbs

Melting Tank 

Melt on demand 7 liter x 2

Auto Feeding System


Gun Model & Tip

LPMS-G08 x 2 / 36.4°

Gun distance

3.94 in – 7.88 in

Ejectors distance

1.97 in

Heated Hose

1.6 m x 2


200-240VAC / 1 Phase / 50Hz

Temperature Control Zones


Temperature Range 

Ambient up to 250°C / 485°F

Max .Power

10 Kw  

Min. Air Pressure

0.5MPa  |  73 Psi

Air Consumption

3.5 ft3/min


Air over oil cylinder

Clamping Force

Max. 5 Tons ( Optional 10 Tons )

Clamping Stroke

5.91 in  

Control System

7 ”HMI , PLC controlled

Safety Protection

See-thru clamp shield, emergency stop button

Max. Mold Set Size

5.75 in x 11.81 in x 5.90 in

Min. Mold Set Size

7.87 in x 5.90 in x 5.90 in